Table 8-1. Event Log Message Types - Comtech EF Data DMD1050TS Installation And Operation Manual

Event Type
Informational
Warning
Minor
Major
Critical
Click Clear Log to clear the event log of all messages. The event log is reset to zero entries.
TRANSEC Module HTTPS Interface

Table 8-1. Event Log Message Types

Event Type (By order of severity – from least to worst case)
Event Description
Normal operational status change; e.g.,
successful password or configuration setting
change.
Status change that the system might not
accept or expect; e.g., setting the future
passphrase without first setting the future
seed key, entering an invalid remote
command, etc.
Error condition that the system should be
able to recover from without affecting the
operation of the system; e.g., encountering
software 'bug', etc.
Such events are not recorded into the
Events Log.
A more severe error that may indicate a
degradation of the stability of the system;
e.g., out-of-range temperature readings for
the TRANSEC Module, etc.
The most severe error level indicating that
system failure has occurred or is imminent;
e.g., memory allocation failure, OS failure,
etc.
Figure 8-5. Event Log Page Cleared
DMD1050TS Satellite Modem Board
Level of Severity / User Action
Minimum. Event logged is for user reference only.
Moderate. User should consult the pertinent
sections of this manual to troubleshoot, and then
repeat command or procedure as needed.
Moderate. User should report issues when
convenient to Comtech EF Data Customer Support.
Maximum. User should contact Comtech EF
Data Customer Support as soon as possible to
address issue.
Maximum. User should contact Comtech EF
Data Customer Support
for RMA / in-factory service.
8–13
Revision 1
immediately to arrange
MN-DMD1050TS