Comtech EF Data DMD1050TS Installation And Operation Manual page 165

Interface | TX Setup Page
Eth Flow Control
Eth Daisy Chain
Eth QOS Type
Eth QOS Queue
CAUTION
Strict Priority can severely limit lower priority traffic.
ETH HDLC
Async Section
Async Mode
ES Interface
ES Baud Rate
ES Bits/Char
Drop Map Section – Not available on the DMD1050TS
Drop Mode
Sat Channel
Terr TSlot
Web Browser
DISABLED
•
ENABLED
•
DISABLED
•
ENABLED
•
NORMAL
•
PORT BASED
•
FAIR WEIGHTED
•
STRICT PRIORITY
•
RADYNE
•
COMTECH
•
MANAGED 570
•
ES-ES
•
ESC ENHANCED
•
RS-232
•
RS-485
•
150 - 19200
•
7
•
8
•
N/A
N/A
N/A
7–43
DMD1050TS Satellite Modem Board
Enable or disable flow control. This is only visible when
Ethernet is selected as the interface type.
Enable or disable the Ethernet Port Daisy Chaining or
enable it on Port 2. This is only visible when Ethernet is
selected as the interface type.
Use to select the priority hierarchy for processing an IEEE
803.0ac Tag, Ipv4 Type of Service Field/Differentiated
Services Field, or Ipv6 Traffic Class Field. The Port Based
priority overrides any standard priority. When operating in
this mode, Port 1 has the highest priority and Port 2 has the
lowest.
Use to select the queue weighting of 8, 4, 2 or 1, so that
even the lowest priority traffic gets some bandwidth. Strict
Priority makes sure that the higher priority traffic transmits
before the lower priority traffic.
RADYNE HDLC is supported by all legacy Radyne products
that do not allow configuration of the HDLC, or Comtech
modems that use the Network Processor card in Gigabit
Bridge mode.
COMTECH HDLC is supported by the SLM5650A Modem
with Ethernet Bridge Card.
MANAGED 570 HDLC is for other Comtech HDLCs, such
as the CDM-570 and CDM-625 in standard bridge mode.
See Table 3-1.
Read only; ES-ES is the normal IBS Async Channel. ESC
ENHANCED is applicable for Closed Net. It uses the
Overhead Signaling bytes in the IBS Overhead to pass
asynchronous data.
Read only; shows the ES interface type.
Read only; shows the ES baud rate in Enhanced Async
Mode.
Read only; shows the 7- or 8-bit data.
N/A
N/A
N/A
Revision 1
MN-DMD1050TS