Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 97

Network Ingress QoS Policy Commands
ingress
Syntax ingress
Context config>qos>network policy-id
Description
This command is used to enter the CLI node that creates or edits policy entries that specify the
to forwarding class mapping packets.
When pre-marked packets ingress on a network port, the QoS treatment through the 7210 SAS-based
on the mapping defined under the current node.
default-action
Syntax default-action fc fc-name profile {in | out}
Context config>qos>network>ingress
Description
This command defines or edits the default action to be taken for packets that have an undefined Dot1p
bits set. The default-action command specifies the forwarding class to which such packets are
assigned.
Multiple default-action commands will overwrite each previous default-action command.
Default default-action fc be profile out
Parameters
fc fc-name — Specify the forwarding class name. All packets with Dot1p bits that is not defined will
profile {in | out} — All packets that are assigned to this forwarding class will be considered in or out
7210 SAS-E OS Quality of Service Guide
be placed in this forwarding class.
Default None, the fc name must be specified
Values be, l2, af, l1, h2, ef, h1, nc
of profile based on this command. In case of congestion, the in-profile packets are preferentially
queued over the out-of-profile packets.
Default
None
Values
in, out
QoS Commands
Dot1p
Page 97