Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 213

packets is still done according to
User can explicitly define the new Dot1P values using these commands.
The no form of the command sets the IEEE 802.1P or IEEE 802.1Q priority bits to default FC-Dot1P
marking map as listed in
Default
Dot1p values are marked according to
Parameters dot1p-value — This value specifies the unique IEEE 802.1P value that will match the dot1p rule. If
dot1p-out-profile
Syntax dot1p-out-profile dot1p-value
no dot1p-out-profile
Context config>qos>access-egress>fc
Description
This command explicitly defines the egress IEEE 802.1P (dot1p) bits marking for fc-name. All pack-
ets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P encapsulation use
the explicitly defined dot1p-value. If the egress packets for fc-name are not IEEE 802.1Q or IEEE
802.1P encapsulated, the dot1p command has no effect. The dot1p-in-profile dot1p-value and
dot1p-out-profile dot1p-value commands will provide the capability to mark Dot1p on an egress
access port for the in and out of profile packets. If the user has not explicitly configured this FC-
Dot1p map the marking of packets is according to FC-Dot1P marking table as listed in
Default Access Egress Policy ID 1 Definition, on page
values using these commands.
The no form of the command sets the IEEE 802.1P or IEEE 802.1Q priority bits to default FC-Dot1P
marking map as listed in
Parameters
dot1p-value — This value specifies the unique IEEE 802.1P value that will match the dot1p rule. If
7210 SAS-E OS Quality of Service Guide
Table 12, Default Access Egress Policy ID 1 Definition, on page
the command is executed multiple times with the same dot1p-value, the previous forwarding
class and enqueuing priority is completely overridden by the new parameters or defined to be
inherited when a forwarding class or enqueuing priority parameter is missing.
A maximum of eight dot1p rules are allowed on a single policy.
Values 0 — 7
Table 12, Default Access Egress Policy ID 1 Definition, on page
the command is executed multiple times with the same dot1p-value, the previous forwarding
class and enqueuing priority is completely overridden by the new parameters or defined to be
inherited when a forwarding class or enqueuing priority parameter is missing.
A maximum of eight dot1p rules are allowed on a single policy.
Values
0 — 7
Table 12, Default Access Egress Policy ID 1 Definition, on page
Access Egress Default Policy Details on page
42. User can explicitly define the new Dot1P
QoS Commands
42.
42.
205.
Table 12,
42.
Page 213