Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 153

Since this FC uses only unicast meter, an entry is required to identify this traffic type explicitly.
Another entry is required to classify broadcast, multicast and unknown-unicast traffic type to the
same FC and use the default meter #11.
FCaf = 1 + 1 + 1 + 0 = 3
Since this FC uses unicast, broadcast and multicast meter, three entries are required to identify
these traffic types explicitly. Unknown-unicast traffic type is classified using the same entry as
multicast traffic type and uses the same meter.
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 1 + 0 = 2
Using the above equation, the total classification entries used = 15 and the total meters used = 6.
If the same policy were to be used for a SAP in an Epipe service, then since all traffic is classified
to a unicast traffic type and since only unicast meters are used, the following are used:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 1 + 0 + 0 + 0 = 1
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 1 + 0 + 0 + 0 = 1
FCl1 = 1 + 0 + 0 + 0 = 1
FCaf = 1 + 0 + 0 + 0 = 1
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 0 + 0 = 1
Using the above equation, the total classification entries used = 5 and the total meters used = 3
(since all FCs used only meter #1, meter #3 and meter #5).
Example 4
sap-ingress 10 create
description"example-policy-3"
num-qos-classifiers 36
7210 SAS-E OS Quality of Service Guide
meter 1 create
rate cir 100 pir 100
exit
meter 2 multipoint create
rate cir 1 pir 20
exit
meter 3 create
rate cir 100 pir 100
exit
meter 4 multipoint create
rate cir 10 pir 100
exit
meter 5 create
rate cir 10 pir 10
exit
meter 6 create
rate cir 11 pir 100
exit
meter 8 multipoint create
rate cir 20 pir 100
Service Egress/Ingress QoS Policies
Page 153