Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 212

QoS Commands
maximum limit on the packets transmitted through the queue. If the SAP is null encapsulated, the
Dot1p value has no meaning.
Any changes made to an existing policy, using any of the sub-commands, will be applied immediately
to all access ports where this policy is applied.
The no form of this command deletes the access-egress policy. A policy cannot be deleted until it is
removed from all access ports where it is applied. When an access-egress policy is removed from a
access port, the access port will revert to the default access-egress policy-id 1.
Parameters policy-id — The value that uniquely identifies the access-egress policy.
create — The keyword used to create an access-egress policy. The create keyword requirement can
fc
Syntax fc fc-name [create]
no fc fc-name
Context config>qos>access-egress
Description
This command defines the fc node within the access egress QoS policy is used to contain the explic-
itly defined Dot1p marking commands for the fc-name.
Note that when the mapping for the fc-name and Dot1p marking is not defined, the node for fc-name
is not displayed in the show configuration or save configuration output.
The no form of the command removes the explicit Dot1p marking commands for the fc-name.
fc-name — Specifies the forwarding class for which Dot1p marking is to be edited. The value given
create — Keyword used to create an access-egress policy. The create keyword requirement can be
dot1p-in-profile
Syntax dot1p-in-profile dot1p-value
no dot1p-in-profile
Context config>qos>access-egress>fc
Description This command explicitly defines the egress IEEE 802.1P (Dot1p) bits marking for fc-name. All pack-
ets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P encapsulation use
the explicitly defined Dot1p-value. If the egress packets for fc-name are not IEEE 802.1Q or IEEE
802.1P encapsulated, the dot1p command has no effect. The dot1p-in-profile dot1p-value and dot1p-
out-profile dot1p-value structure will add the capability to mark Dot1p on an egress access port the in
and out of profile packets. If the user has not explicitly configured the FC-Dot1p map the marking of
Page 212
Values
1 — 65535
be enabled/disabled in the environment>create context.
for fc-name must be one of the predefined forwarding classes in the system.
Values
be, l2, af, l1, h2, ef, h1, nc
enabled/disabled in the environment>create context.
7210 SAS-E OS Quality of Service Guide