Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 151

Using the above equation, the total classification entries used = 11 (since three explicit match
criteria entries map to each of FC H2, L1, and AF along with a default classification rule for BE).
Meters used = 3 (since FCs use only meter #2, meter #3 and meter #11).
Therefore, in this example,
that the system internally uses 18, instead of 16.
If the same policy were to be used for a SAP in an Epipe service, then since all traffic is classified
to a unicast traffic type and since only unicast meters are used, the following is used:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 0 + 0 + 0 + 0 = 0
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 1 + 0 + 0 + 0 = 1
FCl1 = 1 + 0 + 0 + 0 = 1
FCaf = 1 + 0 + 0 + 0 = 1
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 0 + 0 = 1
Using the above equation, the total classification entries used = 4 and the total meters used = 1.
Example 3
sap-ingress 10 create
description"example-policy-2"
num-qos-classifiers16
7210 SAS-E OS Quality of Service Guide
num-qos-classifiers 16
meter 1 create
rate cir 100 pir 100
exit
meter 2 multipoint create
rate cir 1 pir 20
exit
meter 3 create
rate cir 100 pir 100
exit
meter 4 multipoint create
rate cir 10 pir 100
exit
meter 5 create
rate cir 10 pir 10
exit
meter 11 multipoint create
rate cir 1 pir 20
exit
fc "af" create
meter 3
broadcast-meter 2
multicast-meter 4
exit
fc "h1" create
meter 5
broadcast-meter 4
multicast-meter 4
unknown-meter 4
exit
Service Egress/Ingress QoS Policies
is used (i.e. maximum of (12, (2*3))). Note
Page 151