Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 100

QoS Commands
meter
Syntax meter meter-id
no meter
Context config>qos>network>ingress>fc
Description This command overrides the default unicast forwarding type meter mapping for fc fc-name. The spec-
ified meter-id must exist within the policy as a non-multipoint meter before the mapping can be made.
Once the forwarding class mapping is executed, all unicast traffic on a port using this policy is for-
warded using the meter-id.
The no form of this command sets the unicast (point-to-point) meter-id back to the default meter for
the forwarding class (meter 1).
Default meter 1
Parameters
meter-id — Specifies the meter-id. The specified parameter must be an existing, non-multipoint meter
multicast-meter
Syntax multicast-meter meter-id
no multicast-meter
Context config>qos>network>ingress>fc
Description This command overrides the default multicast forwarding type meter mapping for fc fc-name. The
specified meter-id must exist within the policy as a multipoint meter before the mapping can be made.
Once the forwarding class mapping is executed, all multicast traffic on a port using this policy is for-
warded using the meter-id.
The no form of the command sets the multicast forwarding type meter-id back to the default meter for
the forwarding class.
Default
9
Parameters meter-id — Specifies the multicast meter. The specified parameter must be an existing, multipoint
Page 100
defined in the config>qos>network>ingress context.
Values For network policy : 1 — 12 (except 9, the default multipoint meter)
meter defined in the config>qos>network>ingress context.
Values 2— 12
7210 SAS-E OS Quality of Service Guide