End (Package Execution) - Siemens SINUMERIK 840D sl Operating Manual

Display associated system variables button
You open the "End - system variables" dialog via the button
variables). All system variables to be used under "Finish" are listed here.
Information on the system variables·can be found in the System variables for the Finish
dialog (Page 295) section.
Further general information on the system variables can be found in the Reference list system
variables (Page 283) section.
Dialog / Operating instructions
You can find additional information on the property groups "Dialog" and "Operating
instructions" under Package configuration (configuration) (Page 121).
Logbook
The following settings are available for the "Logbook" and are activated when the package is
executed:
Storage location
File name
Note
Storage location logbook
If a storage location has not been configured, the logbook is stored next to the package.
For the package execution with the NCU area, the logbook is also stored on the control under /
card/install.
For a package which runs on the PCU or Windows PC, it is stored under:
d:\UP of the PCU if a PCU is involved.
4.4.2.40

End (package execution)

Dialog view during the package execution (for commissioning engineers / operators)
The "Finish" dialog cannot be deactivated. A file in text format or restricted HTML format can
be displayed on this dialog for postprocessing.
The operator can also be prompted to save the logbook when closing the dialog. A logbook
that can only be opened after a password has been entered is stored as an *.exe file.
You will find additional information on package execution in the section under Package
execution (Page 317).
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
You define the storage location of the logbook here.
Here, you specify the name of the logbook.
Create MyConfig - Expert
4.4 Project folder
(Display associated system
195