Siemens SINUMERIK 840D sl Operating Manual page 334

Create MyConfig - Expert
4.12 Command line call
Call
The commands subsequently shown and all switches and arguments that are used should be
written in one line to a batch file or a command line interface.
Note
Change to the command line interface CMC 4.7
Command line interfaceCMC 4.7 supports the command line interface documented in versions
< CMC 4.7 SP1 HF1.
The new switch /config <"Path of the configuration file"> may not be used within the context
of the old definition.
The new definition of the command line supports the following switches in various different
versions:
Expert.exe
The switches in square brackets are optional.
Version
Expert.exe
[/log <Path log file>] <Path project file>
Example:
Expert.exe
V1.xml" D:\Projects\MyProject.upz
Version
Expert.exe
Example:
Expert.exe
Notes
Observe the following notes for the command line call:
Note
Observe the sequence of the switches
The switches should be written to in the specified sequence.
When doing this, observe the Section "Call" and the table "Significance of the switches".
334
Versions
①
/silent /deploy
<log>] <upz>
②
/verify
①
- deployment with verification run in the silent mode
/silent /deploy [/config <Path config file>] [/protect]
/silent /deploy /config ./update.upcfg /log "D:\Log\L1
②
- only verification run with opening from Expert
/verify [/config <Path config file>] <Path project file>
/verify /config ./update.upcfg D:\Projects\MyProject.upz
[/config <upcfg>]
[/config <upcfg>]
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
[/protect] [/log
<upz>