Siemens SINUMERIK 840D sl Operating Manual page 78

Create MyConfig - Diff
3.5 File comparison
①
Settings tab
②
③
④
⑤
78
When a file is opened, Diff goes through the saved identification configurations from the
top to the bottom - and applies the first appropriate configuration corresponding to what
has been configured under the Settings tab.
As a consequence, the sequence in which the configurations were saved is of signifi‐
cance.
For instance, a configuration that only operates with the file identification function using
the file names should be located after a configuration that operates with the file identifi‐
cation function using the same file names and in addition, the file content.
Configurations that are to be temporarily not used can be deactivated by removing the
checkmark.
A screen form to identify the file (file type) using the file names can be saved in this field.
If, using the file name, a clear identification is not possible, then a character string in the
content of the file - typical for the file type - can be used to identify it.
In this field, when activating the content identification via
describes a character string typical for the particular file type must be saved. Several
regular expressions (one for each line) can also be specified. The comparison configu‐
ration is used as soon as one matches, i.e. a defined character string was found in the
file.
This list box is used to specify which comparison configuration will be used if a file
② ③
described using ,
file comparison configurations (see Configuration (Page 71)).
④
, and is identified. The drop down list box contains all of the
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
③
, a regular expression that
Operating Manual, 11/2016, A5E36537479B-AD