Siemens SINUMERIK 840D sl Operating Manual page 199

Using the buttons, you can modify the representation of the step tree:
Display associated system variables button
You open the "System variables" dialog via the button
The "System variables" dialog shows the list of system variables Up.$Step[<id>] for the
currently selected step.
Information on the system variables can be found under the System variables reference list in
the Steps tab (Page 297) section.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Expand selection
Here, you can either display a selected step or the entire step tree with all substeps
and components.
Reduce selection
Here, you can reduce an individually selected step or the entire step tree to the
main step. Substeps and components are thus no longer visible.
Preview for step tree during the package execution
The project engineer can check the operator view here.
Collapsed steps are not displayed.
Show components
The components for the displayed steps are displayed or hidden via this button.
Display tooltip for steps
Select this option to display tooltips for steps or substeps.
Any existing warning messages are also displayed in the tooltip.
Display step ID
The step IDs are displayed or hidden via this button.
Refresh step tree completely (F5)
Via this button, all of the changes that were made in the entire step tree to steps,
substeps and components are refreshed in the display.
Meaning of the colored display of a link step:
● Blue
The update was successful.
● Red
The update could not be performed because the subproject cannot be reached.
● Purple
During the update, a difference was found in the main project; the step
configuration must be checked. (Purple display only possible for link step that
is managed in the main project.)
Note
The changes are not saved by the update.
Down / Up
Using the arrow keys, you can change the sequence of selected steps, substeps
or components which are located on a level.
Create MyConfig - Expert
4.4 Project folder
(Display associated system variables).
199