Siemens SINUMERIK 840D sl Operating Manual page 16

Installation
2.2 Installation via command line
Parameter
DestinationPath
(optional)
Features
(optional)
DeleteSettings
(optional)
NcuShareService
(optional)
NcuShareServiceShareFold‐
er
(optional)
Example of the control file "OPFILE.txt"
[SETUPREQUESTS]
# Do not display setup dialogs
SetupMode=Batch
# Target drive for installation
DestinationDrive=C
# Target path for installation
DestinationPath="\Program Files\Siemens\Create MyConfig 4.7"
# Component selection for installation
Features=Expert,Topo,Diff,Samples
#
#
# Delete settings from previous installation
# (default: DeleteSettings=0)
DeleteSettings=1
#
# Installing the NcuShareService
# (default: NcuShareService=1)
NcuShareService=1
#
# Select the path for the share folder of the NCuShareService
# Selection of the share folder of the NcuShareService
NcuShareServiceShareFolder=c:\Siemens\NcuShare
16
Description
A path without a specific drive where the software should be
installed can be specified in the parameter.
A default installation path is used if a value is not entered.
Under a 32-bit Windows operating system, for example, the
path is "\Program Files\Siemens\Create MyConfig 4.7"
This parameter is ignored if CMC components are already
installed.
The components to be installed, separated by commas, are
listed in this parameter.
Possible values include Expert, Topo, Diff, and Samples.
The components correspond to the selection in the setup di‐
alog during manual installation.
All of the components are selected if no value is entered.
With this parameter, it is possible to force deletion of settings
from a previous installation.
If the optional parameter is omitted, the prior settings from a
previous installation will be retained.
The NcuShareService is installed with this parameter.
If the parameter is 1, the NcuShareService is installed and, if
the parameter is 0, NcuShareService is not installed.
This parameter is used to specify the path for the share folder. NcuShareServiceShareFold‐
Example
DestinationPath ="\myTools
\Create MyConfig 4.7"
● Install all components:
● Only install component
DeleteSettings=1
NcuShareService=1
er=
c:\Siemens\NcuShare
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Features=Expert,Topo,Di
ff, Samples
"Diff":
Features=Diff