Deploy Topology - Siemens SINUMERIK 840D sl Operating Manual

Identifying the differences in the topologies
After the topologies have been compared, then the result of the comparison is shown in the
lower section. You can jump directly to the location in the topologies where the differences
were identified via the context menu "Go to Difference" or by double-clicking the message line.
6.4.5

Deploy topology

Procedure
To deploy the topology in Topo, proceed as follows:
1. Select the topology that is to be deployed.
2. Set the mode of the topology to deploy this as user-defined topology (*.utz) or comparison
topology (*.ust).
3. Set the correct CNC version.
4. Start the deployment.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Create MyConfig - Topo
6.4 Topo - operation
375