Siemens SINUMERIK 840D sl Operating Manual page 134

Create MyConfig - Expert
4.4 Project folder
Display associated system variables button
You open the "Select offline archive - system variables" dialog via the button
associated system variables). All system variables to be used under "Select offline archive"
are listed here.
Information on the system variables·can be found in the System variables for the Select offline
archive dialog (Page 288) section.
Further general information on the system variables can be found in the Reference list system
variables (Page 283) section.
Dialog / Operating instructions
You can find additional information on the "Dialog" and "Operating instructions" property
groups under Package configuration (configuration) (Page 121).
Offline archives
The following property is available:
List
Input archive
The following property is available:
Preselection
NC part archive (input)
The following property is available:
Preselection
PLC part archive (input)
The following property is available:
Preselection
134
Use the button to open the "List of archives" dialog.
This is where you will find the list of the offline archives to also
be specified in the package, which can be used in the subse‐
quent advance selections and in package execution.
An archive can be selected from which all of the areas con‐
tained for package execution are available.
If a "subarchive (input) is preselected, it must be noted that its
corresponding area is used as replacing area.
An archive can be preselected from which only the NC area for
package execution is used.
An area originating from the "input archive" is thus replaced.
An archive can be preselected from which only the PLC area
for package execution is used.
An area originating from the "input archive" is thus replaced.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
(Display