Siemens SINUMERIK 840D sl Operating Manual page 396

Create MyConfig - Topo
6.8 Axis-drive assignment
Version 1: Axis-drive assignment using I/O addresses
With this selection, the axis numbers are set the same as the drive numbers and the NC I/O
address machine data calculated.
Horizontal arrows always define default values (default connections) of the NC or SINAMICS software.
Figure 6-17 Axis-drive assignment using I/O addresses
Version 2: Axis-drive assignment using the drive number
With this selection, the NC I/O address is set to the default value and the drive numbers are
calculated in the NC axis machine data.
Horizontal arrows always define default values (default connections) of the NC or SINAMICS software.
Figure 6-18 Axis-drive assignment using the drive number
396
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD