System Configuration (Configuration) - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.4 Project folder
After the tgz file has been loaded, the NCU is automatically restarted.
Note
TGZ files generated using "sc backup xyz.tgz" or backups generated using Create MyConfig
can only be used for a new installation.
They cannot be used for an upgrade.
If a backup of CMC is used for a new installation, the archive data it contains will be imported.
Buttons for the package processing dialogs
Information on the general buttons in the dialogs can be found under Meaning of buttons
(Page 126).
4.4.2.24

System configuration (configuration)

You can configure the following property groups for the "System configuration" dialog page:
● Dialog
● Operating instructions
● Offline archives
● NC archive data
● PLC archive data
● HW configuration (SDB)
● DRV archive data / drive configuration
● Dialog scripts
158
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD