Siemens SINUMERIK 840D sl Operating Manual page 161

NC archive data
The following settings are available for the "NC archive data" and are activated when the
package is executed:
Table 4-11 NC archive data
Origin of data
Setting disabled
Preselection of the offline archive
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Note
This selection can be blocked by the project engineer in order to prevent changes by the operator
during the package execution.
Initial state If the "NCU area" was activated during package configuration, the archive data
can be loaded directly from the control with the setting "Initial state".
If the initial state is used, the archive is extracted that was located on the control
when this dialog box was entered.
If the CNC software was installed beforehand, only default data is available in
the archive.
Note
No data is reset when upgrading the CNC software. The archive that is avail‐
able in the system after data migration is used.
Overall reset If this option is used, default data is loaded and then the archive data is backed
up.
Offline archive If this option is used, the output data for the NC area is taken from a stored
SINUMERIK archive.
Yes The selection at "Source of the data" can be blocked by the project engineer
via this option in order to prevent changes by the operator during the package
No
execution.
Under "Preselection of the offline archive", a SINUMERIK archive can be pre‐
selected, pasted, or inserted as link from the list.
Select an archive from the "List of the offline archives", or enter the path of a
file that is located next to the package "/<Path>/<File>",
e.g. "./NC-data.arc".
Note
If data for "Offline Archive" must be entered in the step tree via components,
no SINUMERIK archive must be specified in the preselection.
Create MyConfig - Expert
4.4 Project folder
161