Dialogs - Siemens SINUMERIK 840D sl Operating Manual

The following properties are available:
Table 4-6
Use archive
Use PCU
Use NCU/PPU
NcuShareService
The following properties are available:
Table 4-7
Installation
Uninstallation
Further information on the NcuShareService can be found in the Create MyConfig NcuShare
(Page 417) section or in the online help of the same name.
4.4.2

Dialogs

Overview of dialog pages
Below the project map in the "Dialogs" tab, you can activate the dialog pages to be executed
and configure their contents and behavior.
You can see the dialog list with the dialog pages that can be configured for an example project
below:
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Data areas
Yes
No
Yes
No
Yes
No
NcuShareService
Yes
No
Yes
No
Create MyConfig - Expert
Here, you define whether the data area Archive,
PCU and/or NCU is used when executing the
package.
This configuration affects the target area nodes in
the actions of components (partially also scripts).
Unused nodes are hidden or highlighted in color if
they contain data.
The NcuShareService is installed on the "NCU ac‐
cess" dialog page if it has not been installed yet or
an older versions exists on the PC/PCU.
The service is only required if a Windows package
is to be executed with NCU data area.
The NcuShareService is uninstalled after execut‐
ing the package.
The uninstall can only be performed if the installed
service has the same service version in the current
package.
4.4 Project folder
111