Configuration Of The Topology With Topo - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Topo
6.6 SINAMICS device configuration
● When a user-specified topology is used, the component numbers must also be specified
in addition to the DO names, DO numbers and component names. The use of the DO
names, DO numbers and component names corresponds to the above explanations for
the comparison topology. When the user-specified topology is used, the component
numbers must also be specified. The CU and the NX must contain 1; the numbers on the
CU or NX must not be assigned more than once and must be in the range 2 to 199. In Topo,
the component numbers can also be automatically assigned via the shortcut menu.
● When configuring a user-specified topology, the activation status of the DOs and
components can still be specified.
The following is true:
– 0
– 1
– 2
The status is entered in the following parameters:
– p105 DO activation/deactivation
– p125 Motor Module activation/deactivation
– p145 Sensor Module activation/deactivation
DO list - comparison topology - user-specified topology
The mentioned properties and their specification are summarized in the following table:
Figure 6-11 DO list - comparison topology (VT) - user-specified topology (SOT)
6.6.7

Configuration of the topology with Topo

CMC Topo can be used to configure not only a comparison topology but also a user-defined
topology. The operation of CMC Topo is described in detail in Section Create MyConfig –
Topo (Page 357).
The wiring diagram for the DRIVE-CLiQ connections and some of the properties are identical
for both topologies.
388
inactive and present
active and present
not present
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD