Extended User-Specified Topology - Siemens SINUMERIK 840D sl Operating Manual

6.7

Extended user-specified topology

Requirement
As of the Create MyConfig version V4.7there is also the extended user-specified topology as
a third mode in addition to the comparison and user-specified topology.
Figure 6-14
In addition to the SINAMICS wiring diagram, the extended user-specified topology also
includes NC and DRV data.
The starting basis for the extended user-specified topology is the archive import of a functioning
machine.
After the import, the wiring diagram is displayed as for V4.6. In addition, additional NC and
DRV data are available in the background for a manipulation.
All of the data remain available until it is deleted and can be saved as Topo project <Name>.uptz
During the import, DO variables are automatically assigned to the drive objects (DO). These
are needed for the drive or encoder assignment.
Components can be deleted, added or moved using the known mechanisms such as drag and
drop, copy and paste.
Note
Observe the drive data format
The extended user-specified topology is only possible with ASCII drive data files.
Drive data in the ACX format are not supported.
Drive objects
The extended user-specified topology works only with complete drive objects.
This means that:
● When a DO is moved, the complete dataset is always moved, including all of the
components used in it.
● All of the data of the DO is symbolically displayed by the "Motor module" component (TM,
hub).
● The complete DO is always considered when adding/deleting a motor module.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Extended user-specified topology
Create MyConfig - Topo
6.7 Extended user-specified topology
391