Installation; Overview; Installation Via Command Line; Structure Of The "Opfile.txt" Control File - Siemens SINUMERIK 840D sl Operating Manual

Installation

2.1

Overview

You have two options for installing the Create MyConfig engineering software and the
NcuShareService application on your PC:
● Installation using the installation wizard
Installing the Create MyConfig setup as usual by running the setup file and by manually
working through the setup dialogs.
● Installation via command line
From version 4.6, it can also be automatically installed without any user interaction.
An "OPFILE.txt" control file can be transferred as argument when starting the setup.
The setup process can be preconfigured in this control file. This means that it is no longer
necessary to manually work through the setup dialogs. The following chapter describes the
option for installation via the command line.
2.2

Installation via command line

2.2.1

Structure of the "OPFILE.txt" control file

The file contains the section data [SETUPREQUESTS]as the first entry.
A parameter value is then allocated per line.
Comment lines can start with the "#" character:
Parameter description
Parameters and their possible values are listed in the following table:
Parameter
SetupMode
DestinationDrive
(optional)
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Description
The "Batch" value must be allocated to the parameter to pre‐
vent setup dialogs from being displayed.
The target drive where the software should be installed is
specified in this parameter.
The system drive is used if a value is not entered.
This parameter is ignored if CMC components are already
installed.
2
Example
SetupMode=Batch
DestinationDrive=C
15