The Advantages Of Using Comparison Or User-Specified Topology - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.13 SINAMICS device configuration
4.13.6

The advantages of using comparison or user-specified topology

The configuration of a comparison or user-specified topology withTopo and the use of the file
in the package, offer a number of additional advantages:
Advantages for the configuration of the topology with Topo
● Understandable topology creation thanks to a graphical wiring diagram
● Support with component box, context menu, verification run and graphic / color-coded
visualization
● Printing the wiring diagram of the SINAMICS components with legend for documentation
purposes
● Comparison of topologies
● Import of topologies from drive archives
● Management of DO variables
Advantages of the topology file during the package execution
● The actual wiring of the SINAMICS in the control cabinet can be checked using the machine
topology exported from SINAMICS. Warning or error messages are issued should
deviations occur.
● You can check the properties of the components wired via DRIVE-CLiQ (DO type, article
number, etc.). Wildcards are allowed when specifying the article number, e.g. 1FK7042
xAF7x xFxx.
● Sensor Modules not directly wired to a Motor Module, but rather to a hub or a CU, can be
uniquely assigned to a DO.
● The specification of an OEM-ID is used to assign the SINAMICS-CU local component
number to a particular OEM global unique identifier. When processing the package, the
OEM component number in the DO1 is written to the parameter p7859 [component number].
● For the comparison topology, the DO names, DO numbers and component names specified
by SINAMICS for the "Automatic configuration" can be replaced by user-specific data.
DO names
If a change of the DO name is configured, then this is automatically entered into the
SINAMICS parameter p199 .
DO number
With the drive device configuration, SINAMICS assigns the DO numbers for all DOs at the
CU and the NXs, i.e. on the particular CU starting at 1. For a machine series, it is more
understandable, for example, if the X-drive, irrespective of its positioning in the SINAMICS
group, always has the same number and that the DO numbers in the SINAMICS group are
unique. The value range for the DO numbers lies between 2 and 54.
Component names
The component names can be freely assigned. The names of the SINAMICS components
are displayed on the dialogs and in the screen forms and messages of SINUMERIK Operate.
346
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD