Siemens SINUMERIK 840D sl Operating Manual page 166

Create MyConfig - Expert
4.4 Project folder
Dialog view during the package execution (for commissioning engineers / operators)
In this dialog you set which archive data (NC, PLC, and DRV) will be used later in the
subsequent package stages.
Note
If the "Archive area" is activated on the Package tab, the System configuration dialog must be
parameterized.
To establish communication between the NCK, the integrated CU, and the NX expansion
modules, it is necessary to import an appropriate PLC hardware configuration in the form of
an SDB archive. It is not absolutely necessary that the final hardware expansion is included
in this SDB archive, but only the information valid for this NCU relating to PROFIBUS,
PROFINET, NCU, and NX.
You will find additional information on package execution in the section under Package
execution (Page 317).
Figure 4-30
Buttons for the package processing dialogs
Information on the general buttons in the dialogs can be found under Meaning of buttons
(Page 126).
166
System configuration - commissioning engineer / operator view
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD