Dhcpv4 Vlan Port Configure - ZyXEL Communications XGS2210-28 User Manual

Table 187 IP Application > DHCP > DHCPv4 > VLAN (continued)
LABEL
Delete
Cancel

42.4.7 DHCPv4 VLAN Port Configure

Use this screen to apply a different DHCP option 82 profile to certain ports in a VLAN. To open this screen,
click IP Application > DHCP > DHCPv4 > VLAN > Port.
Figure 322 IP Application > DHCP > DHCPv4 > VLAN > Port
The following table describes the labels in this screen.
Table 188 IP Application > DHCP > DHCPv4 > VLAN > Port
LABEL
VID
Port
Option 82 Profile
Add
Cancel
Clear
Chapter 42 DHCP
DESCRIPTION
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Select the configuration entries you want to remove and click Delete to remove them.
Click Cancel to clear the check boxes.
DESCRIPTION
Enter the ID number of the VLAN you want to configure here.
Enter the number of port(s) to which you want to apply the specified DHCP option 82 profile.
You can enter multiple ports separated by (no space) comma (,) or hyphen (-). For example,
enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
In stacking mode, the first number represents the slot and the second the port number. Enter 1/
1-1/24,2/28 for ports 1 to 24 for the Switch in slot 1 and port 28 for the Switch in slot 2, for
example.
Select a pre-defined DHCP option 82 profile that the Switch applies to the specified port(s) in this
VLAN. The Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the
profile to DHCP requests that it relays to a DHCP server.
The profile you select here has priority over the one you select in the DHCP > DHCPv4 > VLAN
screen.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click this to reset the values above based on the last selected entry or, if not applicable, to
clear the fields above.
Click Clear to reset the fields to the factory defaults.
XGS2210 Series User's Guide
414