Arp Inspection Log Status - ZyXEL Communications XGS2210-28 User Manual

Figure 206 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
VLAN Status
The following table describes the labels in this screen.
Table 116 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
VLAN Status
LABEL
Show VLAN range
Enabled VLAN
Selected VLAN
Apply
VID
Received
Request
Reply
Forwarded
Dropped

26.9 ARP Inspection Log Status

Use this screen to look at log messages that were generated by ARP packets and that have not been
sent to the syslog server yet. To open this screen, click Advanced Application > IP Source Guard > IPv4
Source Guard Setup > ARP Inspection > Log Status.
Chapter 26 IP Source Guard
DESCRIPTION
Use this section to specify the VLANs you want to look at in the section below.
Select this to look at all the VLANs on which ARP inspection is enabled in the section below.
Select this to look at all the VLANs in a specific range in the section below. Then, enter the
lowest VLAN ID (Start VID) and the highest VLAN ID (End VID) you want to look at.
Click this to display the specified range of VLANs in the section below.
This field displays the VLAN ID of each VLAN in the range specified above.
This field displays the total number of ARP packets received from the VLAN since the Switch
last restarted.
This field displays the total number of ARP Request packets received from the VLAN since
the Switch last restarted.
This field displays the total number of ARP Reply packets received from the VLAN since the
Switch last restarted.
This field displays the total number of ARP packets the Switch forwarded for the VLAN since
the Switch last restarted.
This field displays the total number of ARP packets the Switch discarded for the VLAN since
the Switch last restarted.
XGS2210 Series User's Guide
277