ZyXEL Communications XGS2210-28 User Manual page 359

Chapter 35 Link Layer Discovery Protocol (LLDP)
Figure 274 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting (Stacking mode)
The following table describes the labels in this screen.
Table 157 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL DESCRIPTION
Slot (Stacking This field appears only in stacking mode. Click the drop-down list to choose the slot number
mode) of the Switch in a stack.
Port This displays the Switch's port number. In stacking mode, the first number is the slot ID and the
second is the port number. * means all ports.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Management Select the check box(es) to enable or disable the sending of Management Address TLVs on
Address the port(s).
Port Description Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
System Capabilities Select the check box(es) to enable or to disable the sending of System Capabilities TLVs on
the port(s).
System Description Select the check box(es) to enable or to disable the sending of System Description TLVs on
the port(s).
System Name Select the check box(es) to enable or to disable the sending of System Name TLVs on the
port(s).
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
XGS2210 Series User's Guide
359