Ipv6 Snooping Policy Setup - ZyXEL Communications XGS2210-28 User Manual

The following table describes the labels in this screen.
Table 124 Advanced Application > IP Source Guard > IPv6 Source Guard Port Setup
LABEL
Slot (Stacking
mode)
Port (Standalone or
stacking mode)
*
Policy Name
Apply
Cancel

26.16 IPv6 Snooping Policy Setup

Use this screen to dynamically create an IPv6 source guard binding table using a DHCPv6 snooping
policy. A DHCPv6 snooping policy lets the Switch sniff DHCPv6 packets sent from a DHCPv6 server to a
DHCPv6 client when it is assigning an IPv6 address. When a DHCPv6 client successfully gets a valid IPv6
address, DHCPv6 snooping builds the binding table dynamically. To open this screen, click Advanced
Application > IP Source Guard > IPv6 Snooping Policy Setup.
Note: If you do not select Protocol and Prefix Glean, then the Switch cannot perform DHCPv6
snooping.
Figure 218 Advanced Application > IP Source Guard > IPv6 Snooping Policy Setup
Chapter 26 IP Source Guard
DESCRIPTION
This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
This field displays the port number. In stacking mode, the first number is the slot ID and the
second is the port number. If you configure the * port, the settings are applied to all of the
ports.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select an IPv6 source guard policy that the Switch will apply to this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
XGS2210 Series User's Guide
289