ZyXEL Communications XGS2210-28 User Manual page 449

Table 205 SNMP System Traps (continued)
OPTION OBJECT LABEL
errdisable zyErrdisableDetect
zyErrdisableRecovery
poe zyPoePowerPortOverload
(For PoE models
zyPoePowerPortShortCircuit
only)
zyPoePowerPortOverSystem
Budget
zyPoePowerPortOverloadRe
covered
zyPoePowerPortShortCircuitR
ecovered
zyPoePowerPortOverSystem
BudgetRecovered
loginrecord zyAccessControlLoginRecor
d
zyAccessControlLogoutRec
ord
zyAccessControlLoginFail
Table 206 SNMP Interface Traps
OPTION OBJECT LABEL
linkup linkUp
linkdown linkDown
autonegotiation zyPortAutonegotiationFailed
lldp lldpRemTablesChange
Chapter 45 Access Control
OBJECT ID
1.3.6.1.4.1.890.1.15.3.24.4.1
1.3.6.1.4.1.890.1.15.3.24.4.2
1.3.6.1.4.1.890.1.15.3.59.4.1
1.3.6.1.4.1.890.1.15.3.59.4.2
1.3.6.1.4.1.890.1.15.3.59.4.3
1.3.6.1.4.1.890.1.15.3.59.4.5
1.3.6.1.4.1.890.1.15.3.59.4.6
1.3.6.1.4.1.890.1.15.3.59.4.7
1.3.6.1.4.1.890.1.15.3.9.4.1
1.3.6.1.4.1.890.1.15.3.9.4.2
1.3.6.1.4.1.890.1.15.3.9.4.3
OBJECT ID
1.3.6.1.6.3.1.1.5.4
1.3.6.1.6.3.1.1.5.3
1.3.6.1.4.1.890.1.15.3.61.3.1
1.0.8802.1.1.2.0.0.1
XGS2210 Series User's Guide
449
DESCRIPTION
This trap is sent when an error is detected
on a port, such as a loop occurs or the rate
limit for specific control packets is
exceeded.
This trap is sent when the Switch ceases the
action taken on a port, such as shutting
down the port or discarding packets on the
port, after the specified recovery interval.
This trap is sent when the port is turned off to
supply power due to overloading.
This trap is sent when the port is turned off to
supply power due to short circuit.
This trap is sent when the port is turned off to
supply power because the requested
power exceeds the total PoE power
budget on the Switch.
This trap is sent when the port is turned on to
recover from an overloaded state.
This trap is sent when the port is turned on to
recover from a short circuit.
This trap is sent when the port is turned on to
recover from an over system budget.
This trap is sent when users log in.
This trap is sent when users log out.
This trap is sent when users fail in login.
DESCRIPTION
This trap is sent when the Ethernet link
is up.
This trap is sent when the Ethernet link
is down.
This trap is sent when an Ethernet
interface fails to auto-negotiate with
the peer Ethernet interface.
The trap is sent when entries in the
remote database have any updates.
Link Layer Discovery Protocol (LLDP),
defined as IEEE 802.1ab, enables LAN
devices that support LLDP to
exchange their configured settings.
This helps eliminate configuration
mismatch issues.