Aaa Setup - ZyXEL Communications XGS2210-28 User Manual

Table 103 Advanced Application > AAA > TACACS+ Server Setup (continued)
LABEL
Accounting
Server
Timeout
Index
IP Address
TCP Port
Shared Secret
Delete
Apply
Cancel

25.5 AAA Setup

Use this screen to configure authentication, authorization and accounting settings on the Switch. Click
on the AAA Setup link in the AAA screen to view the screen as shown.
Chapter 25 AAA
DESCRIPTION
Use this section to configure your TACACS+ accounting settings.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the TACACS+ server.
This is a read-only number representing a TACACS+ accounting server entry.
Enter the IP address of an external TACACS+ accounting server in dotted decimal notation.
The default port of a TACACS+ accounting server is 49. You need not change this value unless
your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between the
external TACACS+ accounting server and the Switch. This key is not sent over the network. This
key must be the same on the external TACACS+ accounting server and the Switch.
Check this box if you want to remove an existing TACACS+ accounting server entry from the
Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS2210 Series User's Guide
255