Oam Remote Loopback - ZyXEL Communications XGS2210-28 User Manual

Xgs2210 series. intelligent layer 2 gbe switch

Table of Contents

Table 170 Advanced Application > OAM > OAM Configuration (continued)

38.4 OAM Remote Loopback

Use this screen to perform a remote-loopback test. In the OAM Status screen click Remote Loopback to

display the screen as shown.

Figure 298 Advanced Application > OAM > OAM Remote Loopback (Standalone mode)

Chapter 38 OAM

Specify the OAM mode on the port.

Select Active to allow the port to issue and respond to Ethernet OAM commands.

Select Passive to allow the port to respond to Ethernet OAM commands.

Select this check box to enable the remote loopback feature on the port. Otherwise, clear the

check box to disable it.

Select this check box to set the Switch to process loopback commands received on the port.

Otherwise, clear the check box to have the Switch ignore loopback commands received on the

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to save

your changes to the non-volatile memory when you are done configuring.

Click Cancel to begin configuring this screen afresh.

XGS2210 Series User's Guide

Show Quick Links

Table of Contents