Restore Configuration - ZyXEL Communications XGS2210-28 User Manual

Table 193 Management > Maintenance > Firmware Upgrade
LABEL
Status (Stacking
mode)
Version
Current Boot Image
Config Boot Image
Apply
Cancel
(Stacking mode)
Firmware
File Path
Upgrade

44.7 Restore Configuration

Use this screen to restore a previously saved configuration from your computer to the Switch.
Figure 340 Management > Maintenance > Restore Configuration
Type the path and file name of the configuration file you wish to restore in the File Path text box or click
Choose File to locate it. After you have specified the file, click Restore. "config" is the name of the
configuration file on the Switch, so your backup configuration file is automatically renamed when you
restore using this screen.
Chapter 44 Maintenance
DESCRIPTION
This field displays the current stacking status on the Switch.
The Switch has two firmware sets, Firmware 1 and Firmware 2, residing in flash.
• Running shows the version number (and model code) and MM/DD/YYYY creation date
of the firmware currently in use on the Switch (Firmware 1 or Firmware 2). The firmware
information is also displayed at System Information in Basic Settings.
• Firmware 1 shows its version number (and model code) and MM/DD/YYYY creation
date.
• Firmware 2 shows its version number (and model code) and MM/DD/YYYY creation
date.
This displays which firmware is currently in use on the Switch (Firmware 1 or Firmware 2).
Select which firmware (Firmware 1 or Firmware 2) should load, click Apply and reboot the
Switch to see changes, you will also see changes in the Current Boot Image field above as
well.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click the drop-down list to choose the slot number of the Switch in a stack to upgrade the
firmware on this slot. Alternatively, select All to upgrade the firmware for all slots.
Choose to upload the new firmware to (Firmware) 1 or (Firmware) 2.
Type the path and file name of the firmware file you wish to upload to the Switch in the File
Path text box or click Browse to locate it.
Click Upgrade to load the new firmware. Firmware upgrades are only applied after a
reboot. To reboot, go to Management > Maintenance > Reboot System and click Config 1,
Config 2 or Factory Default (Config 1, Config 2 and Factory Default are the configuration
files you want the Switch to use when it restarts).
XGS2210 Series User's Guide
430