Lldp-Med Configuration - ZyXEL Communications XGS2210-28 User Manual

The following table describes the labels in this screen.
Table 158 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
Slot (Stacking
mode)
Port
*
Dot1 TLV
Port-Protocol
VLAN ID
Port VLAN ID
Dot3 TLV
Link
Aggregation
MAC/PHY
Max Frame Size
Power Via MDI
Apply
Cancel

35.7 LLDP-MED Configuration

Click Advanced Application > LLDP > LLDP-MED Configuration to display the screen as shown next.
Chapter 35 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
This displays the Switch's port number. In stacking mode, the first number is the slot ID and the
second is the port number. * means all ports.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port and Protocol
VLAN ID TLVs on the port(s).
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the port(s). All check boxes in this column are enabled by default.
Select the check box(es) to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the port(s).
Select the check box(es) to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the port(s). All check boxes in this column are enabled by
default.
Select the check box(es) to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs
on the port(s).
Note: For PoE models only. The Power Via MDI TLV allows network management to advertise
and discover the MDI power support capabilities of the sending port on the remote device.
• Port Class
• MDI Supported
• MDI Enabled
• Pair Controlable
• PSE Power Pairs
• Power Class
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS2210 Series User's Guide
361