Configuring Arp Inspection - ZyXEL Communications XGS2210-28 User Manual

• They do not use the same space in memory that regular MAC address filters use.
• They appear only in the ARP Inspection screens and commands, not in the MAC Address Filter screens
and commands.
26.19.2.2 Trusted vs. Untrusted Ports
Every port is either a trusted port or an untrusted port for ARP inspection. This setting is independent of
the trusted/untrusted setting for DHCP snooping. You can also specify the maximum rate at which the
Switch receives ARP packets on untrusted ports.
The Switch does not discard ARP packets on trusted ports for any reason.
The Switch discards ARP packets on untrusted ports in the following situations:
• The sender's information in the ARP packet does not match any of the current bindings.
• The rate at which ARP packets arrive is too high.
26.19.2.3 Syslog
The Switch can send syslog messages to the specified syslog server
forwards or discards ARP packets. The Switch can consolidate log messages and send log messages in
batches to make this mechanism more efficient.

26.19.2.4 Configuring ARP Inspection

Follow these steps to configure ARP inspection on the Switch.
Configure DHCP snooping. See
1
Note: It is recommended you enable DHCP snooping at least one day before you enable
ARP inspection so that the Switch has enough time to build the binding table.
Enable ARP inspection on each VLAN.
2
Configure trusted and untrusted ports, and specify the maximum number of ARP packets that each port
3
can receive per second.
Chapter 26 IP Source Guard
Section 26.19.1.4 on page
XGS2210 Series User's Guide
296
(Chapter 48 on page
295.
464) when it