ZyXEL Communications XGS2210-28 User Manual page 311

The following table describes the labels in this screen.
Table 131 Advanced Application > sFlow > Collector
LABEL DESCRIPTION
Collector Enter the IP address of the sFlow collector.
Address
UDP Port Enter a UDP port number the Switch uses to send sFlow datagram to the collector. If you change
the port here, make sure you change it on the collector, too. The default port is 6343.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to reset the fields to the factory defaults.
Index This field displays the index number of this entry. Click on an index number to change the
settings.
Collector This field displays IP address of the sFlow collector.
Address
UDP Port This field displays port number the Switch uses to send sFlow datagram to the collector.
Delete Check the rule(s) that you want to remove in the Delete column and then click the Delete
button.
Cancel Click Cancel to begin configuring this screen afresh.
XGS2210 Series User's Guide
311