Port Details - ZyXEL Communications XGS2210-28 User Manual

The following table describes the labels in this screen.
Table 225 Port Status
LABEL
Slot (Stacking
mode)
Port
Name
Link
State
PD
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Clear Counter

57.2.1 Port Details

Click a number in the Port column in the Port Status screen to display individual port statistics. Use this
screen to check status and detailed performance data about an individual port on the Switch.
Chapter 57 Port Status
DESCRIPTION
This field appears only in stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
This identifies the Ethernet port. In stacking mode, the first number represents the slot and the
second the port number. Click a port number to display the Port Details screen (refer to
388 on page 491).
This is the name you assigned to this port in the Basic Setting > Port Setup screen.
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps, 1000M for 1000Mbps, or
10G for 10 Gbps) and the duplex (F for full duplex or H for half). It also shows the cable type
(Copper or Fiber) for the combo ports. This field displays Down if the port is not connected to any
device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See
142 for more information.
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol), STP, and dot1x are in blocking state, it displays
Blocking.
For PoE model(s) only.
This field displays whether or not a powered device (PD) is allowed to receive power from the
Switch on this port.
This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on the
port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has been up.
Select Port, enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.
XGS2210 Series User's Guide
490
Figure
page