Dhcpv4 Vlan Port Configure - ZyXEL Communications XS1930 Series User Manual

Table 140 IP Application > DHCP > DHCPv4 > VLAN (continued)
LABEL
Delete
Cancel

33.4.7 DHCPv4 VLAN Port Configure

Use this screen to apply a different DHCP option 82 profile to certain ports in a VLAN. To open this screen,
click IP Application > DHCP > DHCPv4 > VLAN > Port.
Figure 194 IP Application > DHCP > DHCPv4 > VLAN > Port
The following table describes the labels in this screen.
Table 141 IP Application > DHCP > DHCPv4 > VLAN > Port
LABEL
VID
Port
Option 82 Profile
Add
Cancel
Clear
Index
VID
Chapter 33 DHCP
DESCRIPTION
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Select the configuration entries you want to remove and click Delete to remove them.
Click Cancel to clear the check boxes.
DESCRIPTION
Enter the ID number of the VLAN you want to configure here.
Enter the number of port(s) to which you want to apply the specified DHCP option 82 profile.
You can enter multiple ports separated by (no space) comma (,) or hyphen (-). For example,
enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
Select a pre-defined DHCP option 82 profile that the Switch applies to the specified port(s) in this
VLAN. The Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the
profile to DHCP requests that it relays to a DHCP server.
The profile you select here has priority over the one you select in the DHCP > DHCPv4 > VLAN
screen.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click this to reset the values above based on the last selected entry or, if not applicable, to
clear the fields above.
Click Clear to reset the fields to the factory defaults.
This field displays a sequential number for each entry. Click an index number to change the
settings.
This field displays the VLAN to which the port(s) belongs.
XS1930 Series User's Guide
271