Loop Guard; Chapter 27 Loop Guard; Loop Guard Overview; What You Can Do - ZyXEL Communications XGS2210-28 User Manual

27.1 Loop Guard Overview

This chapter shows you how to configure the Switch to guard against loops on the edge of your network.
Loop guard allows you to configure the Switch to shut down a port if it detects that packets sent out on
that port loop back to the Switch. While you can use Spanning Tree Protocol (STP) to prevent loops in the
core of your network. STP cannot prevent loops that occur on the edge of your network.
Figure 224 Loop Guard vs. STP
Refer to Section 27.1.2 on page 297

27.1.1 What You Can Do

Use the Loop Guard screen
specific ports.

27.1.2 What You Need to Know

Loop guard is designed to handle loop problems on the edge of your network. This can occur when a
port is connected to a Switch that is in a loop state. Loop state occurs as a result of human error. It
happens when two ports on a switch are connected with the same cable. When a switch in loop state
sends out broadcast messages the messages loop back to the switch and are re-broadcast again and
again causing a broadcast storm.
If a switch (not in loop state) connects to a switch in loop state, then it will be affected by the switch in
loop state in the following way:
• It will receive broadcast messages sent out from the switch in loop state.
• It will receive its own broadcast messages that it sends out as they loop back. It will then re-broadcast
those messages again.

Chapter 27 Loop Guard

for more information.
(Section 27.2 on page 299) to enable loop guard on the Switch and in
XGS2210 Series User's Guide
297
C
H A P T E R

Loop Guard

27