ZyXEL Communications XGS2210-28 User Manual page 461

Figure 366 Management > Diagnostic (Stacking mode)
The following table describes the labels in this screen.
Table 210 Management > Diagnostic
LABEL DESCRIPTION
Ping Test
IPv4 Select this option if you want to ping an IPv4 address. Select - to send ping requests to all
VLANs on the Switch.
IPv6 Select this option if you want to ping an IPv6 address. You can also select vlan and specify
the ID number of the VLAN to which the Switch is to send ping requests. Otherwise, select - to
send ping requests to all VLANs on the Switch.
IP Address/Host Type the IP address or host name of a device that you want to ping in order to test a
Name
connection.
Click Ping to have the Switch ping the IP address.
Source IP Type the source IP address that you want to ping in order to test a connection.
Address
Click Ping to have the Switch ping the IP address.
Count Enter the number of ICMP Echo Request (ping) messages the Switch continuously sends.
Trace Route Test
IPv4 Select this option if you want to trace the route packets take to a device with an IPv4
address. Select - to trace the path on any VLAN.
Note: The device to which you want to run a traceroute must belong to the VLAN
IPv6 Select this option if you want to trace the route packets take to a device with an IPv6
address.
IP Address/Host Enter the IP address or host name of a device to which you want to perform a traceroute.
Name
Click Trace Route to have the Switch perform the traceroute function. This determines the
path a packet takes to the specified device.
you specify here.
XGS2210 Series User's Guide
461