ZyXEL Communications XGS2210-28 User Manual page 389

Figure 299 Advanced Application > OAM > OAM Remote Loopback (Stacking mode)
The following table describes the labels in this screen.
Table 171 Advanced Application > OAM > OAM Remote Loopback
LABEL DESCRIPTION
Remote Loopback Test
Port Enter the number of the port from which the Switch performs a remote-loopback test. In stacking
mode, the first box field is the slot ID and the second field is the port number.
Number of Define the allowable packet number of the loopback test frames.
Packet
Packet Size Define the allowable packet size of the loopback test frames.
Test Click Test to begin the test.
Remote Loopback Mode
Port Enter the number of the port from which the Switch sends loopback control PDUs to initiate or
terminate a remote-loopback test. In stacking mode, the first box field is the slot ID and the
second field is the port number.
Start Click Start to initiate a remote-loopback test from the specified port by sending Enable
Loopback Control PDUs to the remote device.
Stop Click Stop to terminate a remote-loopback test from the specified port by sending Disable
Loopback Control PDUs to the remote device.
Chapter 38 OAM
XGS2210 Series User's Guide
389