ZyXEL Communications XGS2210-28 User Manual page 268

Table 110 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP Snooping
LABEL
Agent running
Delay timer expiry
Abort timer expiry
Last succeeded time
Last failed time
Last failed reason
Total attempts
Startup failures
Successful transfers
Failed transfers
Successful reads
Failed reads
Successful writes
Failed writes
Database detail
First successful access
Last ignored bindings
counters
Binding collisions
Chapter 26 IP Source Guard
DESCRIPTION
This section displays information about the current update and the next update of the
DHCP snooping database.
This field displays the status of the current update or access of the DHCP snooping
database.
none: The Switch is not accessing the DHCP snooping database.
read: The Switch is loading dynamic bindings from the DHCP snooping database.
write: The Switch is updating the DHCP snooping database.
This field displays how much longer (in seconds) the Switch tries to complete the
current update before it gives up. It displays Not Running if the Switch is not updating
the DHCP snooping database right now.
This field displays when (in seconds) the Switch is going to update the DHCP snooping
database again. It displays Not Running if the current bindings have not changed
since the last update.
This section displays information about the last time the Switch updated the DHCP
snooping database.
This field displays the last time the Switch updated the DHCP snooping database
successfully.
This field displays the last time the Switch updated the DHCP snooping database
unsuccessfully.
This field displays the reason the Switch updated the DHCP snooping database
unsuccessfully.
This section displays historical information about the number of times the Switch
successfully or unsuccessfully read or updated the DHCP snooping database.
This field displays the number of times the Switch has tried to access the DHCP
snooping database for any reason.
This field displays the number of times the Switch could not create or read the DHCP
snooping database when the Switch started up or a new URL is configured for the
DHCP snooping database.
This field displays the number of times the Switch read bindings from or updated the
bindings in the DHCP snooping database successfully.
This field displays the number of times the Switch was unable to read bindings from or
update the bindings in the DHCP snooping database.
This field displays the number of times the Switch read bindings from the DHCP
snooping database successfully.
This field displays the number of times the Switch was unable to read bindings from the
DHCP snooping database.
This field displays the number of times the Switch updated the bindings in the DHCP
snooping database successfully.
This field displays the number of times the Switch was unable to update the bindings in
the DHCP snooping database.
This field displays the first time the Switch accessed the DHCP snooping database for
any reason.
This section displays the number of times and the reasons the Switch ignored bindings
the last time it read bindings from the DHCP binding database. You can clear these
counters by restarting the Switch or using CLI commands. See the CLI Reference
Guide.
This field displays the number of bindings the Switch ignored because the Switch
already had a binding with the same MAC address and VLAN ID.
XGS2210 Series User's Guide
268