ZyXEL Communications XGS2210-28 User Manual page 443

Figure 350 Management > Access Control > Logins
The following table describes the labels in this screen.
Table 201 Management > Access Control > Logins
LABEL DESCRIPTION
Administrator
This is the default administrator account with the "admin" user name. You cannot change the default
administrator user name. Only the administrator has read/write access.
Old Password Type the existing system password (1234 is the default password when shipped).
New Password Enter your new system password.
Retype to Retype your new system password for confirmation.
confirm
Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give users higher
privileges via the CLI. For more information on assigning privileges see the Ethernet Switch CLI Reference Guide.
User Name Set a user name (up to 32 ASCII characters long).
Password Enter your new system password.
Retype to Retype your new system password for confirmation.
confirm
Privilege Type the privilege level for this user. At the time of writing, users may have a privilege level of 0,
3, 13, or 14 representing different configuration rights as shown below.
• 0 - Display basic system information.
• 3 - Display configuration or status.
• 13 - Configure features except for login accounts, SNMP user accounts, the
authentication method sequence and authorization settings, multiple logins, administrator
and enable passwords, and configuration information display.
• 14 - Configure login accounts, SNMP user accounts, the authentication method
sequence and authorization settings, multiple logins, and administrator and enable
passwords, and display configuration information.
Users can run command lines if the session's privilege level is greater than or equal to the
command's privilege level. The session privilege initially comes from the privilege of the login
account. For example, if the user has a privilege of 5, he/she can run commands that requires
privilege level of 5 or less but not more.
Chapter 45 Access Control
XGS2210 Series User's Guide
443