ZyXEL Communications XGS2210-28 User Manual page 285

Figure 213 Advanced Application > IP Source Guard > IPv6 Static Binding Setup (Standalone mode)
Figure 214 Advanced Application > IP Source Guard > IPv6 Static Binding Setup (Stacking mode)
The following table describes the labels in this screen.
Table 122 Advanced Application > IP Source Guard > IPv6 Static Binding Setup
LABEL DESCRIPTION
IPv6 Static Binding
Source Address Enter the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address Enter the source MAC address in the binding. If this binding doesn't check this field, select
Any.
Note: You cannot choose Any for all three of MAC Address, VLAN and Port. You
VLAN Enter the source VLAN ID in the binding. If this binding doesn't check this field, select Any.
Port (Standalone or Specify the port(s) in the binding. If this binding has one port, select the first radio button and
stacking mode) enter the port number in the field to the right. In stacking mode, the first field is the slot ID and
the second field is the port number. If this binding applies to all ports, select Any.
Add Click this to create the specified static binding or to update an existing one.
Chapter 26 IP Source Guard
must fill in at least one.
XGS2210 Series User's Guide
285