Load Stacking Default; Factory Default - ZyXEL Communications XGS2210-28 User Manual

In the Maintenance screen, click a configuration button next to Reboot System to reboot and load that
1
configuration file. The following screen displays.
Figure 334 Reboot System: Confirmation
Click OK again and then wait for the Switch to restart. This takes up to two minutes. This does not affect
2
the Switch's configuration.
Click Config 1 and follow steps 1 to 2 to reboot and load configuration one on the Switch.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
Click Factory Default and follow steps 1 to 2 to reboot and load default configuration settings on the
Switch.
Click Custom Default and follow steps 1 to 2 to reboot and load Custom Default configuration settings on
the Switch. This will save the custom default configuration settings to both Configuration 1 and
Configuration 2.

44.5.1 Load Stacking Default

Follow the steps below to reset the Switch back to the stacking defaults. The master Switch login
information will not be reset.
Click the Stacking Default button to clear all Switch configuration information you configured and return
1
to the stacking defaults.
Click OK to continue or Cancel to abort.
2
Figure 335 Load Stacking Default: Start
If you want to access the Switch web configurator again, you may need to change the IP address of
3
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).

44.5.2 Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
Click the Factory Default button.
1
Chapter 44 Maintenance
XGS2210 Series User's Guide
427