Set Radius Authentication Switch-Service-Type-Required - Avaya 106760804 Command Reference Manual

set radius authentication switch-service-type-
required
Command Mode
Description
Syntax
Sample Output
Systems
Document No. 10-300090, Issue 1
Global Configuration.
If you enable switch-service-type-required, the switch recognizes only
Access Accept messages that have the correct group name included. This
setting prevents the switch from incorrectly allowing access to users that
may have a user account on the RADIUS server but should not be allowed
access to the switch. If this setting is disabled, any user account that is not
assigned to a group could log in to the switch.
To Enable:

set radius authentication switch-service-type-required

enabled
To Disable: set radius authentication switch-service-type-required
disabled
The following command enables the switch-service-type-required setting:
(configure)# set radius authentication switch-service-type-
required enabled
P550R, P580, P880, and P882.
RADIUS
24-9