Table of Contents
Advertisement
network area
Command Mode
Description
Syntax
Sample Output
Systems
Document No. 10-300090, Issue 1
OSPF Router Configuration.
Defines the interfaces on which OSPF runs and defines an area ID for those
interfaces. To disable OSPF routing for interfaces defined with the <ip-
address> <wildcard-mask> pair, use the no form of this command.
To Enable:
network <ip-address> <wildcard-mask> area <area-id>
To
[no] network <ip-address> <wildcard-mask> area <area-
Disable:
id>
Table 19-19. Parameters, Keywords, Arguments
Name
<ip address>
<wildcard-mask>
<area-id>
The following command defines network area on the interface running at
10.0.7.123 and with area ID 1.1.1.1.
(configure router:ospf)# network 10.0.7.123 255.0.0.0 area
1.1.1.1
P550R, P580, P880, and P882.
Definition
IP address of the interface on which OSPF runs.
The inverse of a network mask. Enter a 32-bit number in
four-part, dotted decimal format. Place ones in the bit
positions that you want to mask.
This parameter specifies a range of IP addresses. For
example, to specify all IP addresses in the 10.10.70 subnet,
enter 10.10.70.0 0.0.0.255.
Area ID for the interface.
OSPF
19-27
Advertisement
Table of Contents
