Table of Contents
Advertisement
set port network-error-detection
Command Mode
Description
Syntax
Document No. 10-300090, Issue 1
Global Configuration.
Configure network error detection and recovery (NEDR) for a port or ports.
To Enable:
set port network-error-detection <mod-port-range> [action
{notify | disable-port}] [rising-threshold <rising-threshold-
value>] [falling-threshold <falling-threshold-value>]
[interval <interval seconds>]
To Disable:
network-error-detection {<mod-port-range> | all} action
off
Table 18-3. Parameters, Keywords, Argument
Name
<mod-port-range>
all
action {notify |
disable-port | off}
Definition
The slot number of the module, and, either port number,
or range of port numbers. Enter the port ranges in the
format Px-Py. For example:
• To specify port 1 on the module in slot 3, enter 3/1.
• To specify ports 1 through 5 on the module in slot
3, enter 3/1-5.
Disables NEDR on all ports on all modules in the switch.
all can be used only with off.
Action that NEDR performs when the rate of errors
exceeds the threshold. The options are:
notify - Logs the event in the event log
disable-port - Disables the port and logs the event in the
event log.
Note: A port will be disabled if the rate of errors equals
or exceeds the threshold. Make sure a redundant
protocol is configured.
off - Disables NEDR on the port or ports that you specify.
The default setting is notify.
NEDR and IEDR
1 of 2
18-5
Advertisement
Table of Contents
