Chapter 21
set port network-error-detection
Command Mode
Description
Syntax
21-30
Global Configuration.
Configure network error detection and recovery (NEDR) for a port or ports.
To Enable:
set port network-error-detection <mod-port-range> [action
{notify | disable-port}] [rising-threshold <rising-threshold-
value>] [falling-threshold <falling-threshold-value>]
[interval <interval seconds>]
To Disable:
network-error-detection {<mod-port-range> | all} action
off
Table 21-26. Parameters, Keywords, Argument
Name
<mod-port-range>
all
action {notify |
disable-port | off}
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Definition
The slot number of the module, and, either port number,
or range of port numbers. Enter the port ranges in the
format Px-Py. For example:
• To specify port 1 on the module in slot 3, enter 3/1.
• To specify ports 1 through 5 on the module in slot
3, enter 3/1-5.
Disables NEDR on all ports on all modules in the switch.
all can be used only with off.
Action that NEDR performs when the rate of errors
exceeds the threshold. The options are:
• notify - Logs the event in the event log
• disable-port - Disables the port and logs the event
in the event log.
Note: A port will be disabled if the rate of errors equals
or exceeds the threshold. Make sure a redundant
protocol is configured.
• off - Disables NEDR on the port or ports that you
specify.
The default setting is notify.
1 of 2