set diffserv plp
Command Mode
Description
Syntax
Systems
Document No. 10-300090, Issue 1
* Important: This command is for future functionality and is not
currently supported.
Global Configuration.
Assigns a packet loss probability (PLP) to a DiffServ code point (DSCP).
set diffserv plp {low | high} dscp <dscp-start-range> [<dscp-end-range>]
Table 23-7. Parameters, Keywords, Arguments
Name
{low | high}
<dscp-start-range>
[<dscp-end-range>]
* Note: While the PLP for a DSCP can be configured and displayed, the
PLP is applied only when RED is enabled on a port.
P550R and P880, 80-series modules only.
P580 and P882.
Definition
The PLP that you want to assign.
The first DSCP in the range of DSCPs that
you want to assign the PLP to. DSCPs range
from 0 to 63.
The last DSCP in the range of DSCPs that you
want to assign the PLP to. DSCPs range from
0 to 63.
80-Series QoS
23-15