Lens Safety Cable - Barco HDF W22 User And Installation Manual

3. Physical installation
3.2.5

Lens safety cable

When using the safety cable ?
The lens safety cable must be used in any circumstances to protect a mounted lens in the lens holder.
Configuration differences
There are two different configurations for the safety cable. The configuration used depends on the used carrying handle or hoisting
eye.
• Configuration A applies when connecting the projector to the bottom carrying handle.
• Configuration B applies when connecting the projector to the hoisting eye.
Necessary parts
• Safety Cable (750 mm, Ø3 mm)
• Cable clamp M4
• Shackle 7x70 mm
• 4 x Cable clip (16x16 mm, Ø4 mm)
How to mount the cable
1. Paste four cable clips on the lens as illustrated (reference 1). Orient the open side of the clips towards the front of the lens.
2
Image 3-24
2. Snap the first loop end of the safety cable into one of the following clips and let the loop end point downwards.
a) Configuration A: Use the upper clip on the side of the cable bundle (reference 2, image 3-24).
b) Configuration B: Use the upper clip on the non-wired side (reference 2, image 3-25).
3. Slide the rest of the cable around the lens counterclockwise. Click the cable into every clip it passes in this loop.
Note: Make sure the cable passes between the lens and the cable bundle.
4. Slide the cable through the loop end at the beginning of the cable.
42
1
Image 3-25
2
1
R5905158 HDF SERIES 08/12/2016